Pistoletas montažinėms/montavimo putoms tefloninis (YT-6743)

The gun is intended for the application of polyurethane foams. High quality - thanks to the use of appropriate, quality materials of stainless steel, aluminum and brass. Elements most exposed to dirt and damage as a result of aggressive foams and corrosion have been additionally protected with a PTFE coating.
Purpose / Application
The gun facilitates such works as sealing, installing windows and doors, filling insulation gaps, sealing and insulating partitions, and insulating walls and roofs.
Usage
Usage:
1. Getting started
- Shake the container well with foam for about 15 seconds.
- Screw in the adjusting screw on the back of the gun until it stops, completely blocking the movement of the trigger lever.
- Remove the lid from the foam container, then screw the container into the gun cap until you feel a resistance.
- Then unscrew the adjusting screw on the back of the gun by turning it counterclockwise until the threaded part of the adjusting screw appears - the threaded part of the adjusting screw should remain screwed into the gun body.
- Press the trigger and fill the gun with foam.
- The gun is ready for use.
- A stream of foam flows when the trigger lever is pressed.
- Releasing the pressure of the trigger lever stops the flow of foam.
- The volume of the mounting foam stream is adjusted by turning the adjusting screw.

2. Activities after finishing work
Screw in the adjustment screw as far as it will go to block the movement of the trigger lever.
It is recommended not to unscrew the foam container from the gun. Make sure the gun is always screwed on, although partly filled, to keep the foam inside the gun under pressure. This prevents foam from drying inside the gun.
If the gun has been out of use for more than a month, clean the gun with a mounting foam cleaner. Do not allow foam to dry inside the gun. Dried foam can only be removed mechanically. Leaving dried foam inside the gun leads to irreversible obstruction of the gun.

3. Reusing the gun
Shake the gun strongly with the container attached for about 15 seconds. Using a sharp knife, cut off the tip of the hardened foam. Unscrew the adjustment screw counterclockwise and release enough foam to make the flow uniform. After this, the gun is ready for use.

4. Replacing the container
If foam has stopped coming out of the container, replace it with a new one. To find out if the container is completely unobstructed, point the nozzle towards the dust container and push the trigger lever until the gun nozzle is completely unclogged. Install a new container immediately without cleaning the gun and proceed as described in step 1.

5. Cleaning the gun
Unscrew the container from the gun. Attach the spray tip to the container with the cleaning agent and clean the remains of fresh foam on the gun. Remove the spray tip and screw the detergent container into the gun. Proceed in the same way as for the foam container (item 1). Fill the gun with cleaning agent and leave for about 10 minutes. Press the trigger lever again and clean the inside of the gun with fresh cleaner. Unscrew the container with the cleaning agent. Using a cloth, remove cleaning agent residue from the container and gun connection
and cover them with a thin layer of petroleum jelly. Do not clean the gun with corrosive agents. With continuous use of the gun, clean the gun as described above every 2-3 months
Technical data
Index number YT-6743
EAN 5906083967436
Brand Yato
Gross weight (kg) 0.5000
Master Carton MC 20
Pal 240
Material brass, stainless steel
Surface finish with PTFE coating